Company
Our stock range includes tool steel grades, suitable for cold work, hot work, and plastic mould applications, and high speed specifications. It is stocked in a wide variety of shapes and sizes Ground tool products are supplied such as Silver Steel and Ground Flat Stock. Grades M2 and M42 High Speed tool bits are supplied in standard and non standard sizes
|
D2 Tool Steel (X153CrMoV12) |
|
12% chrome steel, very high resistance against abrasive and adhesive wear due to a high volume of hard carbides in the steel matrix, good toughness, very good dimensional stability, high compressive strength, very good base material for PVD/CVD coating as well as nitriding due to its secondary hardening properties. Similar to AISI D2. Applications: Cutting, punching, stamping tools, shear blades, thread rolling dies, cold extrusion dies, drawing and bending tools, flanging and straightening rolls, fine cutting tools, deep drawing tools, plastic moulds for abrasive polymers. |
|
H13 Tool Steel |
||||||||||||||
|
High strength at elevated temperatures, high hot wear esistance, good toughness, thermal conductivity and resistant to hot cracking, limited water cooling possible. Applications: Standard material for hot forming tools, extrusion tools, forging dies, pressure casting tools, hot shear knives, tools for plastic industry. Also available in EFS and ESR condition where better properties are required.
|
1.2510 100MnCrW4
|
DIN |
AISI |
JIS |
Chemical Composition |
|||||||||||
|
C |
Si |
Mn |
P |
S |
Co |
Cr |
Mo |
Ni |
V |
W |
Cu |
|||
|
1.2510 |
O1 |
SKS3 |
0.90 to 1.05 |
0.15 to 0.35 |
1.00 to 1.20 |
< 0.035 |
< 0.035 |
- |
0.15 to 0.35 |
- |
- |
0.05 to 0.15 |
0.50 to 0.70 |
- |
Properties :
General purpose oil hardening medium alloyed cold work tool steel with minimum size change, high impact strength
and hardenability, good edge holding, abrasion resistance and machinability properties, dimensionally stable during
heat treatment, high surface hardness and sufficent toughness after hardening and tempering.
