Machine introduction
This machine have powered outfeed conveyor and powered conveyorized turntable system and is able to transport an wrapped load from the turntable to the outfeed conveyor if there is no wrapped load on the outfeed conveyor. The operator can start wrap cycle by remote control allowing the operator to do other tasks. This arrangement eliminates the need for operators to place unwrapped loads on the floor, then pick them up again when the turntable is clear. During the machine auto wrap one palletized load, the operator can get one new unwrapped load, if there is no pallet on turntable, operator can put the new one, then take the wrapped load from the outfeed conveyor to the warehouse. Compared to a single turntable system. It increase fork lift efficiency and reduce handling time.
Wrapping size(L*W) |
(500~1200)×(500~1200)mm |
Turntable diameter |
1800mm |
Turntable Height |
625mm |
Turntable weight capacity |
2000kg |
Turntable speed |
0-15rpm |
Machine weight |
700kg |
Electrics |
380V 50HZ 3 Phase |
Power |
2.3kw |
Air |
0.4—0.6 Mpa |
Packing efficiency |
40-60 loads/h base on load |
Turntable capacity(optional) |
2500kg, 3000kg |
Controls
OMRON PLC control system
Photo-eye pallet height sensor
0-9 separate top ,bottom & up-down wrap count selectors
Photoeye sensing delay
Reinforce wrap allow more wrap on same location
Film Tension Control adjustment on the panel
0—15RPM variable turntable speed by frequency changer
Separate variable carriage up/down speed
Cycle pause capability
Separate start, reset and emergency stop buttons
Manual carriage up/down switch
Turntable jog button
Conveyor Jog (for each conveyor)
Dust-tight Precious Metal Slip-ring for long reliable service
Turntable
1800mm Diameter Structural steel plate
625mm high profile turntable
Position turntable alignment
Soft start/ Soft stop
Heavy duty chain drive
Table Fully Shrouded for Greater Personnel Safety
Film Carriage
Powered pre-stretch system up to 250% to min film consumption(Prestretch ratio can be specially made according your requirements.)
Carriage door opens for effortless roll change and thread film
Film delivery variable speed by separate DC Drive Motor
Film dancer-bar with variable speed output
Heavy duty double-chain carriage lift, calm and safety
Conveyor
Heavy Structural steel
Option
Packing height: 2800mm
Turntable diameter: 2000mm
All rollers driven
Heavy Duty Conveyor Guards
Adjustable Leg Height
Different Roller Diameters and Roller Spacing Available
Conveyor Speed:12m per min(other speed available)
Photo-eye Pallet Sensing and sequencing
Technology Data
Addition conveyors & other type ( chain, belt ) available
Other
Hinged mast for easy handling
Forklift transportable